300M Wireless-N Access Point
WPS mode
：
Provide two ways: PBC
(Push-Button Configuration) and PIN code.
PBC
：
Select the PBC or press the WPS button on
the front panel of the device for about one second
(Press the button for about one second and WPS
indicator will be blinking for 2 minutes, which
means the WPS is enabled. During the blinking
time, you can enable another device to implement
the WPS/PBC negotiation between them. At
present, the WPS only supports up to 32 clients
access. Two minutes later, the WPS indicator will
be off. If more clients are added, repeat the above
steps).
PIN
：
If this option is enabled, you need to enter a
wireless client’s PIN code in the field and keep the
same code in the WPS client.
The user is required
to enter an 8-digit PIN Code.
WPS summary
：
Show Wi-Fi current protection
state, authentication mode, encryption method,
etc.
Note ： Press the WPS/Reset button for 1
second on the front panel to run PBC.
Press for 7 seconds, the device’s
setting will restore to default setting.
The access client has to support WPS
function when you implement WPS
57
To Next Page
Loading...
