Wireless N300 Home Router
64
Chapter 8 Tools
8.1 Reboot
Reboot the device to activate your settings. WAN connection will be
disconnected during reboot.
8.2. Restore to Factory Default Settings
Click the Restore to Factory Default button to reset device to factory
default settings. You need to reconfigure the device for Internet access as
well as many other settings including wireless settings.
The factory default settings are listed below:
IP Address: 192.168.0.1
Subnet mask: 255.255.255.0.
Note:
To activate your settings, you need to reboot the device after you reset it.
8.3 Back/Restore
Backup: Once you have configured the device the way you want it, you can
save these settings to a configuration file on your local hard drive that can
later be imported to your device in case that the device is restored to factory
default settings. To do so, follow below instructions:
To Next Page
Loading...
Need help?
General
