Wireless N300 Home Router
67
2. Port: This is the management port to be open to outside access. The
default setting is 8080. Do NOT change it unless instructed by your ISP.
3. IP Address: Here you can specify the IP Address Range for remote
management (When set to 0.0.0.0, the device becomes remotely
accessible to all the PCs on Internet or other external networks).
4. OK: Click to activate your settings.
Note:
1. To access the device via port 8080, enter "http://x.x.x.x:8080" where
"x.x.x.x" represents the the device's Internet IP address and 8080 is the
remote admin port. Assuming the device's Internet IP address is
220.135.211.56, then, simply replace the "x.x.x.x" with
"220.135.211.56" (namely, http://220.135.211.56:8080).
2. Leaving the IP address field at "0.0.0.0" makes the device remotely
accessible to all the PCs on Internet or other external networks;
populating it with a specific IP address, say, 218.88.93.33, makes the
device only remotely accessible to the PC at the specified IP address.
8.6 Time
This page is used to set the router’s system time. You can choose to set the
time manually or get the GMT time from the Internet and the system will
automatically connect to NTP server to synchronize the time.
Note:
Configured time and date info will be lost when the device gets disconnected
from power supply. However, it will be updated automatically when the
device reconnects to Internet. To activate time-based features (e.g. firewall),
the time and date info shall be set correctly first, either manually or
automatically.
To Next Page
Loading...
