11N Wireless Broadband Router User Guide
45
¾ WPS mode: Provide two ways: PBC (Push-Button
Configuration) and PIN code.
¾ PBC: Select the PBC and click Ok, or press and
hold the WPS button on the back panel of the
device for about one second. The WPS LED
indicator will be flashing for 2 minutes, which
means the WPS is enabled. During this time
(flashing WPS LED), you can enable the wireless
client to implement the WPS/PBC negotiation
between them. When the WPS connection is
completed, the LED indicator will be continuously lit.
To add more clients, repeat the above steps.)
¾ PIN: If this option is enabled, you need to enter a
wireless client’s PIN code in the field and keep the
same code in the WPS client.
¾ Reset OOB: Press this button, the WPS client will
be in an idle state, and the WPS indicator will turn
off. AP will not respond to the WPS client’s
connection request and will set the security mode
as Open-None (Disable) mode.
NOTE: The use of WPS function requires the wireless
adapter to support this function.
5.2.2 WPA- PSK
WPA guarantees to protect WLAN users’ data and only
the authorized network users can have access to WLAN.
To Next Page
Loading...
Need help?
General
