IB 9010958 (08- 2013) 1
INSTRUCTION BULLETIN
No. 9010958
Machine: T12
Published: 08- 2013
Rev. 00
NOTE: DO NOT DISCARD the Parts List from the Instruction Bulletin. Place the
Parts List in the appropriate place in the machine manual for future
reference. Retaining the Parts List will make it easier to reorder
individual p arts and will save th e cost of ordering an entire kit.
NOTE: Numbers in parenthesis ( ) are reference numbers for parts listed in Bill of Materials.
Installation instructions for kit number 9010351
SYNOPSIS:
This kit contains the parts needed to install a warning light onto T12 scrubbers equipped with an
optional overhead guard.
Please follow step-by-step instructions.
SPECIAL TOOLS / CONSIDERATIONS: NONE
(Estimated time to complete: 1.5 hours)
PROTECT THE ENVIRONMENT
Please dispose of packaging mat erials , used machine component s
such as bat t er ies and f luids in an envir onment ally saf e way
accor ding t o local wast e dis posal regulat ions.
Always remember to recycle.
PREPARATIO N:
1. Park the machine on a clean level surface,
turn off the machine, and remove the key.
FOR SAFETY: Before leaving or servicing
machine, stop on level surface, turn off
machine, and remove key.
2. Disconnect the battery cable from the
machine.
W ARNING: Always disconnect battery
cables from machine before working on
electrical components.
INSTALLATION:
1. Insert the rubber grommet (8) into the hole in
the overhead guard. (Fig. 1)
2. Route the strobe light (1) wires down through
the rubber grommet (8) in the overhead
guard. (Fig. 1)
3. Use two M5 pan screws (2), two flat washers
(3), and two M5 hex nuts (4) to install the
strobe light (1) onto the overhead guard.
(Fig. 1)
4. Use two M6 hex screws (6) and two flat
washers (7) to install the light guard (5) onto
the overhead guard. (Fig. 1)
To Next Page
General
