USE and CARE Guide
9001525 Rev 01 (06- 05) www.tennantco.com
FOR SAFETY : DO NOT operate machine unless operator manual is read and understood.
BEFORE EACH USE
1. Sweep floor before
scrubbing.
6. FaST Model - Check
FaST- PAK level. Replace
PAK as needed.
2. Check battery
meter charge level.
Recharge if needed.
7. FaST Model - Check
FaST - PAK supply hose
for proper connection.
3. Check scrubbing
brush or pad. Replace if
worn.
8. Check scrub head
skirt for damage.
4. Check sq u eeg ee
blade wiping edge.
Rotate blade if worn.
9. For Conventional
Scrubbing Only - Fill
solution tank with water
(140° max.) and add
5. Make su re recovery
tank is empty and screen
is clean.
approved cleaning
agents.
FaST Model - USE CLEAR
COOL W ATER ONL Y. DO
NOT add cleaning agents
into the solution tank,
FaST solution system
failure may result.
AFTER EACH USE
1. Drain and clean out
recovery tank.
6. Clean sq u eeg ee
blades.
2. Remove and rinse
off recovery tank screen.
7. Clean machine with
an all purpose cleaner
and damp cloth.
3. Drain and rinse out
solution tank.
8. FaST Model -
Connect FaST- PAK
supply hose to storage
plug when not in use.
4. Remove and clean
the solution tank filter.
9. Recharge batteries if
machine was used 30
minutes or more. Check
battery fluid level before
5. Remove and clean
pad or brush.
charging. Fluid level
should cover battery
plates by 1/4”. DO NOT
OVE R FI LL.
Wet/Lead Acid Batteries
MONTHLY: Refer to Operator’s Manual for further details. ANNUALLY:
1. Clean batteries. Use
a strong mixture of
baking soda and water.
2. Check for loose
battery cable
connections.
3. Lubricate all pivot
points and rollers with a
water resistant grease.
4. Clean and inspect
recovery tank seal.
Replace if damaged.
FaST Model -
Clean or replace the
injector o rifice plate an d
filter screen.
ATTENTION: FOR MACHINE REPAIRS, CONTACT AN AUTHORIZED SERVICE CENTER.
To Next Page
Need help?
General
