KIT NO. 9003295 (120v), 9003296 (230v)
On--Bo ard Ch arger Kit
Page1of4
Models: T5
9003301 Rev. 00 (01--07) Tennant Company Customer Service: (800) 553--8033 or (763) 513--2850
INSTALLATION INSTRUCTIONS:
Installation Time: 2 Hours
TOOLS REQUIRED: 9/16”, 5.5mm, 10mm and 13mm
Sockets, 4mm Hex Wrench, Phillips Scr e wdr iv e r,
Prying Tool, Blue Threa d A dhe s iv e
PREPARATION
1. Park the machine on a clean level surface.
2. Turn off the machine and remove the key.
FOR SAFETY: Before installing kit, stop on
level surface, turn off machine, and remove
key.
3. Remove the (2) bolts that hold the machine’s
right side panel in place, then remove the
side panel from machine (Figure 1).
Remove Front
Batteries
Fig. 1
4. Disconnect the positive and negative
battery cables and remove the two front bat-
teries from machine.
FOR SAFETY: Wear protective gloves and eye
protection when handling batteries and battery
cables. Avoid contact with battery acid.
INSTALLATION
1. Lower the squeegee lift lever to relieve ten-
sion on the lift cable, then remove the squee-
gee lift bracket. Remove the red charger plug
assembly and charger interlock switch from
the bracket. Discard the interlock switch
(Figure 2).
Part No. Description Qty.
1022874 Charger , 120v (Kit #9003295) 1
1026909 Charger , 230v (Kit #9003296) 1
1025642 Cord, Power, 120v (Kit #9003295) 1
1026325 Cord, Power, 230v (Kit #9003296) 1
609062 Screw , Trs, M5 x 0.80 x 12, Phl, SS 3
610906 Hook, Cord 2
1024965 Bolt, Shld, 08MMD x 030mm, M06 x 1.0 2
611311 Spring, Cmpr, 0.40OD .05WIR, 0.5L 2
01684 Washer, Flat, 0.27B 0.69D .05, SS 3
08712 Nut, Hex Lock, M6 x 1.00 SS, NL 2
01683 Washer, Flat, 0.22B 0.50D .05, SS 2
1022059 Panel, Side 1
26395--2 Clamp, Cable, Stl, 0.38D x 0.38W 1
1028175 Label, Instr . (Charger Settings) 1
1024779 Label, Side, T5 1
1024780 Label, Side, T5 FaST 1
600624 Label, Parking Brake (TNV Machine only) 1
130773 Tie, Cable, Nylon 6
Kit Contents
IMPORTANT: Failure to remove these parts may re-
sult in electrical damage to the machine.
Remove
Charger Plug
Remove interlock
Switch
Fig. 2
2. Move to the front of the battery compartment
and remove the control box cover to acce ss
the wire connections (Figure 3).
Remove
2Screws
Fig. 3
To Next Page
Need help?
General
