On--Board Charger Kit
INSTALLATION INSTRUCTIONS --
Continued
Page2of4
KIT NO. 9003295 (120v), 9003296 (230v)
9003301 Rev. 00 (01--07) Tennant Company Customer Service: (800) 553--8033 or (763) 513--2850
3. Remove the red (#1B) and black (#13C)
wires coming from the charger plug. Discard
charger plug assembly (Figure 4).
Removeredwire#1B
Remove black wire #13C
Fig. 4
4. Remove the machine’s left side panel. It will
be replaced at step #10 by the new panel
supplied in the kit.
To remove the side panel:
a. Remove the 3 mounting screws as
shown (Figure 5).
3 Mounting Screws
Fig. 5
b. Lower the recovery tank and pry out the
top left edge of the panel to remove
(Figure 6).
Fig. 6
5. Mount the on--board charger to the machine
in the location shown, using just the top two
mounting screws at this step. Use a small
amount of blue adhesive on the screw
threads. Route double black wires from the
charger up the left side, across the top and
down to the squeegee bracket as shown.
Plug these wires into the yellow (#4A/4B)
and blue (#26) wires that were originally on
the charger interlock switch (Figure 7).
Route charger wires
along channel
Route charger
wires below bracket
Attach charger
wires to yellow
and blue wires
Use (2) each
609062 Screw and
01683 Washer
Fig. 7
6. Route the red and black charger wires for-
ward to the control box and attach them
where the old charger plug wires were re-
moved. Take special care to properly re --
tighten all hardware. Loose connections will
cause electrical damage to the machine. Re--
attach control box cover (Figure 8).
To Next Page
Loading...
