7000-6
76
Venting with pressure kit AGCO Axles
1. Park the machine on flat level ground.
2. Fully dump the loader bucket and lower it to the
ground.
3. Lower the backhoe stabilizers and raise the rear
wheels clear of the ground.
4. Stop the engine.
5. Ensure the brakes are adjusted correctly (see
page 4).
6. Check the brake system fluid level (see page 4).
7. Fit the pressure purging kit.
8. Make sure the left vent screw (1) is closed and
open the right vent screw (1). Do not operate the
brake pedals.
9. Close the right vent screw (1) when the fluid
exhausting vent screw is clear and free of
entrapped air. Make sure the brake fluid in the
reservoir remains above the danger mark at all
times.
10.Depress the left brake pedal 1/2 in (12 to 15 mm).
11. Open the left vent screw (1).
12. Close the left vent screw (1) when the fluid
exhausting vent screw is clear and free of
entrapped air.
13. Operate the left and the right brake pedals. Make
sure the operation is firm and not “spongy”.
14. Only do step 12 if the operation of the brake
pedals is not yet firm.
15. Repeat steps 8 through 14 until the operation of
the brake pedals is firm.
16. Latch the left and the right brake pedals together.
17. Remove the plastic tubes (2) and the containers.
18. Check the brake system fluid level (see page 4).
789M297A
1
2
To Next Page
Loading...