Note:
If any of the safety signs shown in this section are missing or damaged, contact
your dealer to obtain a replacement.
Key (continued)
12. Entanglement hazard (engine compartment)
13. Burn/Scald hazard (engine compartment)
14. Skin (oil) injection hazard
15. Crush hazard (lift arm brace)
16. Crush Hazard (Lift arms)
17. Crush hazard (run over)
18. Clean undercarriages notice
19. Tie down locations
20. Burn hazard (engine compartment)
2 SAFETY
15
Burn Hazard
Hot fluid under pressure can scald.
Allow the machine to cool thoroughly
before opening.
2030-595
Burn Hazard
Contact with hot surfaces can
cause burns.
• Do not touch hot
components!
• Allow the machine to
cool thoroughly prior to
servicing.
2030-601
Entanglement Hazard
Rotating parts can cause personal injury.
Keep away from fan and belt while the
engine is running. Stop engine before
servicing.
2030-600
CRUSH HAZARD
Contact with moving machine can
result in death or serious injury.
Keep clear of moving machine.
2030-593
Crush Hazard
Death or serious injury can result
from contact with moving lift arm or
attachment.
Keep clear of lift arms and
attachments.
2030-592
Injection Hazard
Escaping fluid under pressure can
penetrate skin, causing serious injury.
• Relieve internal pressure before
disconnecting any line or fitting.
• Keep away from leaks or pinholes.
• Use cardboard to check for leaks.
Fluid injected into skin must be surgi-
cally removed within a few hours by a
doctor familiar with this type of injury
or gangrene will result.
2030-602
Crush Hazard
Death or serious injury can result
from contact with moving lift arm or
attachment.
Install lift arm brace prior to servicing.
2030-594
Inspect undercarriages daily for
accumulation of debris. If debris
is present, clean thoroughly with
a pressure washer. If debris is
allowed to build up, it can cause
premature component wear and
decrease machine performance.
2085-253
NOTICE
To Next Page
Loading...
