Terex PT30 - ANSI Safety Signs and Locations

2.4 ANSI Safety Signs
The safety signs are located in/on the machine as indicated. (Descriptions of the
symbols are provided in section 2.3)
Key
1. Fall hazard
2. Crush / fall hazards (inside cab enclosure)
3. Fall / rollover hazards / read operator’s manual (inside cab enclosure)
4. Skin (oil) injection hazard
5. Explosion / burn hazard (read operator’s manual) (engine compartment)
6. Clean undercarriages notice
7. Crush hazard (run over)
8. Crush hazard (lift arm brace)
9. Crush hazard (lift arms)
10. Tie down locations (on chassis, beneath lift arm)
11. Fire hazard (read operator’s manual) (inside cab enclosure)
2 SAFETY
14
CRUSH HAZARD
Contact with moving machine can
result in death or serious injury.
Keep clear of moving machine.
2030-593
Crush Hazard
Death or serious injury can result
from contact with moving lift arm or
attachment.
Keep clear of lift arms and
attachments.
2030-592
Crush Hazard
Death or serious injury can result
from contact with moving lift arm or
attachment.
Install lift arm brace prior to servicing.
2030-594
Fall Hazard
Serious injury or death can result
from falling.
Use the provided access system when
entering or exiting the machine.
2030-597
Injection Hazard
Escaping fluid under pressure can
penetrate skin, causing serious injury.
• Relieve internal pressure before
disconnecting any line or fitting.
• Keep away from leaks or pinholes.
• Use cardboard to check for leaks.
Fluid injected into skin must be surgi-
cally removed within a few hours by a
doctor familiar with this type of injury
or gangrene will result.
2030-602
Fire Hazard
Flammable debris can collect near hot
components and lead to a fire.
Read Operator’s manual
Keep engine, exhaust and chassis
areas free of debris.
2030-599
Explosion/Burn Hazard
Will cause death, burns or
blindness due to ignition of
explosive gasses or contact
with corrosive acid.
• Keep all flames/sparks
away!
• No Smoking!
• Read and understand
all manuals prior to
operation.
2030-603
Read Operator’s Manual
Read and understand the operator’s manual
and all safety signs prior to operating or
maintaining the machine.
Improper operation or maintenance can re-
sult in serious injury or death.
No Riders
Fall Hazard
Falling from a machine can result in serious
injury or death
.
Carry loads low. Load unload and turn on
level ground. Travel on inclines with heaviest
end of machine uphill.
Rollover/Ejection Hazard
Serious injury or death can result.
2030-598
Fasten Seat Belt
Crush Hazard
Rollover can crush and result in serious injury or death.
Do not use the bucket/attachment as a work platform.
Fall Hazard
Falling can result in serious injury or death.
2030-596
1
4
9
11
5
8
7
3
2
Inspect undercarriages daily for
accumulation of debris. If debris
is present, clean thoroughly with
a pressure washer. If debris is
allowed to build up, it can cause
premature component wear and
decrease machine performance.
2085-253
NOTICE
6
10