32 SoundSystem SiXPack 5.1 +
Headphone Operation.
Instead of using an amplifier system, you can also use headphones. The Line In is alternatively
useable as a headphone output by activating the onboard (60mWatt an 32 Ohm) amplifier by
changing the position of Jumper (JP1). Carefully, move the small plastic jumper from position A
to position B.
15
Position A - headphone amplifier deactivated... (Line In mode)
51
Position B - ... and activated. (headphone operation)
Safety Instruction
Please remember to switch off all (analog) devices before connecting
them. This is to avoid the danger of an electric shock - even a weak one
- it also protects your speaker membranes and your hearing from sud-
den signal spikes. For digital devices, the volume of your playback sys-
tem should at least be turned to low.
To Next Page
Loading...
