TerraTec SiXPack 5.1+ - Appendix; FAQ - Frequently Asked Questions and Their Answers

SoundSystem SiXPack 5.1 + 77
Appendix.
FAQ – Frequently asked questions and their answers.
Do I have to move jumpers and change dip switch settings before I install the sound card?
The following jumper settings are possible:
Jumper
Position
PositionPosition
Position
A
AA
A
Effect
Position
B
Effect
JP1
3 - 5
4 - 6
In this position the Line IN
is active
1 - 3
2 - 4
In this position the Line In is con-
verted to Headphone Out
JP2
3 - 5
4 - 6
TTL ( CD IN )
1 - 3
2 - 4
S / PDIF IN
JP3
1 - 2 External digital In active 2 - 3 Internal digital In active
* The default position is position A.
I can't change the IRQ for the SiXPack 5.1+ in the Device Manager.
PCI cards are configured automatically via the Bios, Plug & Play or ACPI of the operating
system. These mechanisms do not allow for the manual alteration of the IRQ via the Device
Manager. If it were necessary to assign another IRQ to the card, it is possible to install the
card into another PCI slot, possibly swapping PCI slots with another card. In addition, one
BIOS or another offers the option of permanently assigning IRQs to individual PCI slots. In
any event, get advice from the manual for your motherboard.
There is no sound coming from the sound card.
· Pay attention that when using only one speaker set you need to use the first line output
(Line Out 1).
· Check the connections between sound card and loudspeakers.
· Are the active speakers or Hifi system turned on?
· Check the level controllers in the SiXPack 5.1+ Control Panel. Ensure in particular that
none of the mute switches have been activated because this would turn off the sound
output.