Terratrip GeoTrip - Dis Fly; Pwr; Probe

Page 15 of 20
12.4 DIS FLY:
Press DIS FLY and the ‘on the fly’ distance adjustment indicators will be shown over
the 1/10ths of the Total distance display. Pressing DIS FLY again will move the fly
adjustment to the 1/100ths of the Total display. Press /\ or \/ to adjust the distance.
If DIS FLY is pressed and no adjustments are made, then after 3 seconds the fly
adjustment will move back 1/100ths on the Total display.
DIS FLY adjustment can be disabled by holding DIS FLY whilst turning the unit on.
One of the following indicators will be shown DIS /\ / \/ - On or DIS /\ / \/ - Off.
When DIS /\ / \/ - Off is shown, DIS FLY is disabled.
If DIS FLY is pressed and held for 3 seconds then the remote display (if fitted) will
switch between Interval distance, speed and average speed (303 only), and Interval
distance and speed. The remote display will show only interval distance on the 202
Classic.
12.5 +/-:
Changes count direction for the trip meter. If the display shows ‘Count +’ then the
tripmeter will count up, and if it shows ‘Count -’ or ‘REVERSE’ it will count down.
The tripmeter will only show ‘REVERSE’ if the external reverse signal is connected
to the reversing lights on the vehicle (see: 15.5 Fig 5. T011G Hand held RZU &
T008 Foot operated RZU for connections and the pin number).
12.6 PWR
Press PWR briefly to turn the unit on.
Press and hold PWR for approximately 5 seconds, and after a long beep the tripmeter
will power down.
Note: The tripmeter will not power down whilst in any menu setting screens.
12.7 /\:
Pressing ‘up’ in distance mode will ‘nudge’ the hundredths up.
In menu items, ‘up’ is used to navigate or select various menu items.
12.8 PROBE:
Pressing PROBE will cycle between probes off, probe 1 and probe 2.
If PROBE is held for 2 seconds, and the unit has a GPS module fitted then the unit
will select the GPS probe. A short press on PROBE will return to standard probes.