TES TES-133 - 5-13 RS232 Communication

20
B. To Enter Auto Datalogging mode
1. Press
key until the beeper sound to enter this mode. The
“A-M INTV” marks are displayed, when the “A-M” mark is
disappear one time, one set of reading is stored to the memory.
2. The maximum memory capacity is 38000 sets.
3. Press for 3 seconds or key to exit this mode.
C. To Clear Auto Datalogged memorized data
1. Press key to turn off the meter.
2. Press and hold down key then press key to turn on
the meter, LCD will show “CLr no M” mark, press key one
time, LCD will show “CLr no A-M” mark, press  key select
“ ” or “ ”, then press key exit this mode. If you
select yes the all auto datalogged memorized data memory will
be cleared.
5-13 RS232 Communication
Press
key 3 seconds the beeper will sound three times
to turn on this mode.