1. GENERAL INDEX
Page
1. GENERAL INDEX 1
2. GENERAL DATA AND PRESCRIPTIONS 3
2.1 MANUFACTURER 3
2.2 COMMUNICATIONS WITH THE MANUFACTURER 3
2.3 TYPOLOGY AND USING FIELD 3
2.4 PERFORMANCES 3
2.5 TECHNICAL CHARACTERISTICS 4
2.6 ACOUSTIC EMISSION 4
2.7 GENERAL PRESCRIPTIONS FOR THE MACHINE USE 4
2.8 GENERAL PRESCRIPTIONS FOR THE OPERATOR CHARGED OF THE MACHINE USE 4
2.9 GENERAL PRESCRIPTIONS FOR THE OPERATOR CHARGED OF THE MACHINE
MAINTENANCE 5
2.10 KNOWLEDGE AND CARE OF THE INSTRUCTION MANUAL 5
2.11 ENVIRONMENTAL CONDITIONS OF USE 5
2.12 TEMPERATURE LIMITS FOR HYDRAULIC OIL 6
2.13 USE NOT ALLOWED 6
2.14 RESPONSIBILITY 6
2.15 APPLIED NORMS 7
3. TRANSPORT AND POSITIONING INSTRUCTIONS 8
3.1 MACHINE LIFTING 8
3.2 TRANSPORT TYPOLOGIES AND PACKAGE 8
3.3 UNPACKING 8
3.4 ASSEMBLY OPERATIONS 9
3.5 TRANSPORT ON TRAILER 9
3.6 POSITIONING AND ANCHORING 9
4. INSTRUCTION FOR USE – STAND-ALONE MACHINE 11
4.1 PRESCRIPTIONS FOR THE OPERATOR 11
4.2 CONTROLS 11
4.3 PRELIMINARY OPERATIONS 11
4.4 MACHINE SET-UP 12
4.5 ELECTRONIC MULTI-FUNCTIONS DISPLAY PAGES 13
4.6 MACHINE START-UP 14
4.7 PULL CONTROL SETTING 15
4.7.1 PULL LIMITING DEVICE SETTING 15
4.7.2 PULL PROGRAMMING DEVICE SETTING 16
4.8 CONNECTION MACHINE - HYDRAULIC HEAD OR REEL WINDER 17
4.9 BACK PULL OF THE HYDRAULIC HEAD OR OF THE REEL WINDER SETTING 17
4.10 USE OF THE MACHINE WITH INDEPENDENT BULL-WHEELS (1-2) 18
4.11 USE OF THE MACHINE WITH MECHANICALLY CONNECTED BULL-WHEELS (1+2) 19
4.12 USE OF THE MACHINE WITH HYDRAULICALLY CONNECTED BULL-WHEELS (1+2) 21
4.13 USING OF TENSION SYNCHRONIZER DEVICE 22
4.14 USING OF ELECTRONIC SPEED SYNCHRONIZER DEVICE (OPTIONAL) 22
4.15 ROPE LOCKING CLAMP (OPTIONAL) 23
4.16 POINTS TO REMEMBER 23
4.17 END OF OPERATIONS 23
5. INSTRUCTION FOR USE – CONNECTED MACHINES 24
5.1 GENERAL ASPECTS 24
5.2 MACHINES SET-UP 25
5.3 CONNECTED MACHINES OPERATIONS 27
5.4 PULL CONTROL SETTING 27
5.4.1 PULL LIMITING DEVICE SETTING 27
5.4.2 PULL PROGRAMMING DEVICE SETTING 27
5.5 USING OF ELECTRONIC SPEED SYNCHRONIZER DEVICE (OPTIONAL) 28
To Next Page
Loading...
