6 Using the product
19
The displays appear in the specified sequence.
✓ Instrument is in operating status Rec or End:
> Press [GO] in order to change between displays of
highest saved reading, lowest saved reading, upper
alarm value, lower alarm value, battery life and last
reading.
The displays appear in the specified sequence.
6 Using the product
6.1. Connecting a sensor
Observe the following points when connecting sensors to
data logger and measuring points.
> Ensure correct polarity of the plugs.
> Press the plugs firmly into the ports to ensure leak
tightness. However, do not apply force!
> Make sure that the plugs are firmly connected to the
data logger or that the connections are closed with
blanking plugs.
> Ensure correct positioning of the sensor to avoid
disturbing influences affecting the measurement.
> testo 175 T3: Always make sure that you connect the
sensor configured (via the software testo Comfort
Software) to the individual sockets. The numbers of the
connections are printed on the housing.
6.2. Programming data logger
In order to adapt the programming of your data logger to
your individual requirements, you require the testo Comfort
Software Basic 5 software. It is available in the Internet as
a free download requiring registration
www.testo.com/download-center.
The instructions for the installation and operation
of the software can be found in the testo Comfort
Software Basic 5 instruction manual that is
downloaded together with the software.
Shop for Data Logging products online at: www.DataLoggerSto re.com 1.888.610.7664
To Next Page
Loading...
