6 Using the product
20
6.3. Menu overview
The menu overview shows exemplary display
representations of the data logger testo 175-T2.
The display must be switched on to be able to
show the corresponding indications. This is
accomplished with the software testo Comfort
Software.
The indication in the display is updated according
to the programmed measurement rate. Only
readings from active channels are displayed.
The channels are also activated via the software
testo Comfort Software.
The symbols for upper or lower alarm value light
up in operating states Rec and End, if the
programmed alarm value has been exceeded or
fallen short off.
After 10 seconds without operating a key the
display will return to its initial state.
Shop for Data Logging products online at: www.DataLoggerSto re.com 1.888.610.7664
To Next Page
Loading...
