Testomat ECO - Basic Programming; Program Value Settings; Basic Programming Structure

15 / 19
PROGRAM - MENU
Testomat ECO
BASIC PROGRAM
ENTER
PROGRAM VALUES
MODE OF OPERAT.
Display of unit
Type of reagent
Limit values
Flush time
Interval
Water meter
Function LV1
Function LV2
Hysteresis LV1
Hysteresis LV2
Function Stop
Interface
ENTER
BOB operation
TIME CONTROLLED *
Volume interval
TYPE TH2005
Type TH2025 *
Type TH2100
Type TH2250
LV1:0,25°dH
LV2:0,35°dH
FLUSH 10s
Function off *
FUNCTION ON
DURATION *
Impulse
Interval
Time 00m:10s
HYSTERESIS LV2 1
TYPE 0-20 mA
Type 4-20 mA *
Time 10m
Volume 000l
DISPLAY °dH *
Display °f
Display ppm CaCO3
Display mmol/l
1 L/IMPULSE
10 l/Impulse
5 l/Impulse
100 l/Impulse *
500 l/Impulse
2.5 l/Impulse
1000 l/Impulse
Imp./l xxx.x
DURATION *
Impulse
Interval
Two point
Time 00m:10s
HYSTERESIS LV2 1
NORM.OPEN CONT.
Norm.closed con *
BASIC PROGRAM
After you have entered the menu with "ENTER", you can carry out the BASIC PROGRAMMING of the unit.
PROGRAM VALUES
To call up the factory-set basic default setting, briefly hold down the "M" and "i" key while switching the unit "ON".
Values and settings are described in the structure of the basic program.
Structure of the BASIC PROGRAMMING
Abbreviations: s = seconds m = minutes, h = hours, d = days, l = litres
To call up the factory-set basic default setting, briefly hold down the “M“and “i“ key while switching the
unit“ON“. CAUTION the last set of programming will be erased!