18 / 19
SPARE PARTS LIST Testomat
®
ECO
Item
No.
Pressure regulator
40120 Regulator / filter housing
40129 Regulator plug T2000, kpl.
11225 Flow regulator valve (1 - 8 bar)
11230 Retaining pin for regulator plug
11217 Inlet filter
11218 Spring for inlet filter
40121 Inlet connector
40153 Plug in connector - G 1/4" -6
Measuring chamber
40173 Sight-glass window 30 x 3 with seal
40170 Sight-glass window 30 x 3
40176 Sight-glass retaining disc
33253 Screw spindle M3x40
40032 Latch fastener TL 800-7-1
11203 Plastic plug
40022 Measuring chamber T2000
Holding block for measuring chamber
40030 Holding block complete (without measuring
40050 Magnetic stirrer
40186 Plug in connector -G 3/8" -10
40018 Solenoid valve, 2/2-Way
40181 Rear guide bar for measuring chamber 5 x 60
Dosning pump DOSIClip®
40001 Jet pump complete, complete
40011 Suction capillary complete, complete
40016 Pressure capillary complete
37232 Base circuit board TI, complete
34668 Magnet 24 VDC
32046 Plastic cover CNH 45 N
Bottle connection/Suction tube
40131 Screwed cap with bottle insert T2000
40130 Screwed cap GL32 - only
40135 Bottle insert for screwed cap with push-fit suction
Item
No
Electrical components
31582 Fuse M4A
37245 Base circuit board T-ECO, complete 230V
40192 Control circuit board T-ECO, complete.
40071 EPROM T-ECO
40190 Cable sleeve 5 -7
40191 Cable sleeve 7 -10
40197 Mains on / off switch Testomat 2000
40198 Cover for Mains on / off switch
31713 Multi-pin strap cable 10 pol. with EMI filter clamp
40096 Multi-pin strap cable 26 pol. with EMI filter clamp
40060 Cable loom 2V complete (for valves)
40062 Cable loom 2P complete (for max. 2 dosing pumps)
40200 Cable loom for Mains on / off switch complete
31622 Fuse T0,16A
31592 Fuse T1,0A
Spare parts requirement for 2 -3 years of operation
40173 Sight-glass window 30 x 3 with seal 2 x
11217 Inlet filter (optional) 1 x
40124 Gasket set T2000 (after maintenance) X*
31622 Fuse T0,16A 1
31592 Fuse T1,0A 1
X* Accurate operation of the TESTOMAT
®
ECO can
be assured only with regular maintenance and
replacements of seals / gaskets (see text on
maintenance).
Accessories:
Order no.
040123 Optional adapter for water inlet (Quick-
acting plug and -coupling).
(Applicable only with optional pressure control)
Reagents:
Order no.
152005 TH2005 Water hardness 0.89 - 8.93 ppm CaCO
3
152025 TH2025 Water hardness 4.47 - 44.7 ppm CaCO
3
152100 TH2100 Water hardness 17.9 - 179 ppm CaCO
3
152250 TH2250 Water hardness 44.8 - 448 ppm CaCO
3
To Next Page
Loading...