3TESUP Electronics Ltd. All rights reserved. ©2023 | www.tesup.com
2. General
HERA WIND PRO USER MANUAL
2.1 GENERAL INSTRUCTIONS
Before you begin installing, read this entire owner’s manual. Following the instruction and
recommendations in this manual will help assure safe and enjoyable use of your new renewable
energy system. Please take the time to read through this manual prior to assembly.
• Place this instruction manual in a safe place for reference.
• TESUP Wind Turbines can only be used with TESUP Charge Controllers and TESUP selling
Inverters.
• There has to be constant load consumption for the wind turbine system (wind turbine,
charge controller and inverter) to work smoothly without stopping and heating. That is why
we recommend grid connected systems only.
• Wind turbines, charge controllers and inverters have to be installed outdoors.
• Do not install your wind turbine on a windy or dusty day with wind speed more than 8m/s.
Wait until a calm day to install or perform maintenance on your turbine with activation of
brake.
• Listen to your turbine, if you hear any mechanical noise, maintenance may be required,
please contact your turbine dealer.
• After installation re-adjust and tighten the screws and bolts.
• Adhere to proper grounding techniques as established by the National Electrical Code.
• Your wind turbine must be installed in accordance with this manual and local and national
building code. Incorrect installation may void your warranty.
• Wind Turbine blades spin at a potentially dangerous speed, this must be respected. Never
approach a turbine in motion.
• Never open the turbine body and expose the generator unless you are instructed to do so by
a TESUP engineer. Opening the turbine body and modications to the turbine system will
void your warranty.
• Do not place your charge controller, inverter or battery under direct sunlight or close to any
heat source. Make sure to have a dry environment where there is no damp, rain, corrosion,
vibration and electromagnetic interference.
• Note wire size prior to wiring. Any under sizing of wire can be potentially dangerous.
• Check the manual brake periodically.
• Check the battery health periodically. The low battery voltage and improper connection can
cause over-spin issues.
2.2 OPERATING & INSTALLING CONDITIONS
Please make sure that:
• The wind turbine system has been erected correctly by a suitably trained person.
• All operating personnel have read and fully understood this translation of the original
instructions
• The wind turbine system is properly maintained and repaired.
To Next Page
Loading...
