9
Switching Modes
Note: Make sure the power switch on the side of the X500Pro is turned on before
use.
The pause function switches the X500Pro from the operating mode to the
selected mode, and it can be paused by the following operations:
Sleep mode means that the X500Pro is stopped and the indicator light is off. If
the X500Pro is not active for 10 minutes, it will enter Sleep mode automatically.
Press on the remote controller to wake it up.
Note
: If the X500Pro is out of service for a long time, please turn the power switch off.
Press on the remote control to pause it.
Under the Standby mode, press on the X500Pro or on the
remote control to start the robot.
Start
Pause
Wake Up
To Next Page
Loading...
