27
EN
INSTRUCTIONS FOR USE
SECONDARY FUNCTIONS
FILTER
- Use the UP-DOWN arrows to set the
minutes.
- Press OK to conrm and return to the
INFO MENU. The massage function will
start up at full power.
- To cancel the operation, press EXIT.
- If no buttons are pressed for 1 5 seconds
the panel will return to the INFO MENU.
- The ashing icon and the word FILTER
indicate that the function is active.
- Press EXIT to return to READY MENU
mode.
INFO
THE OPERATION OF THE RECIRCULATION PUMP, OR OF THE SPRING FUNCTION (DEPENDING ON THE
MODELS) TAKES PLACE:
• DURING THE FILTRATION INTERVALS SET BY THE CUSTOMER
• DUE TO WATER HEATING REQUIREMENTS
• FOR A LIMITED PERIOD OF TIME AFTER EACH USE OF THE PRODUCT FUNCTIONS
• IF THERE IS A RISK OF THE WATER FREEZING.
THE MINIMUM NUMBER OF FILTER HOURS THAT CAN BE SET MAY VARY ACCORDING TO THE HOT TUB/
MINIPOOL MODEL.
WHEN THE FEED IS SWITCHED ON AGAIN AFTER THERE HAS BEEN AN INTERRUPTION TO THE ELECTRICAL
FEED, THE MINIPOOL AUTOMATICALLY GOES INTO FILTER MODE IF THE FILTER TIME PERIOD IS STILL
OPERATIVE.
IN SPECIFIC OPERATING CONDITIONS, FOLLOWING MANUAL OR AUTOMATIC FILTER CYCLES, OR WHEN
THERE IS A RISK OF WATER FREEZING, IT MAY OCCUR THAT ONE OR MORE WHIRLPOOL PUMPS OR THE
BLOWER (IF FITTED) WILL SWITCH ON AND REMAIN ON FOR LONGER THAN USUAL. THIS OPERATING MODE
SHOULD NOT BE CONSIDERED AS A SYSTEM PROBLEM, UNLESS AN ERROR MESSAGE APPEARS ON THE
DISPLAY. WE RECOMMEND WAITING FOR THE FUNCTION TO SWITCH OFF AUTOMATICALLY.
THE FILTER FUNCTION MUST BE PROGRAMMED WITH ALL OF THE HOT TUB/MINIPOOL FUNCTIONS
SWITCHED OFF.
To Next Page
Loading...
