TEXA RC3 - Analogue Measurements

3.2 Analogue measurements
In this mode, the RC3 rev counter can use one of the three analogue modes
provided.
Based on the cable which is connected, the RC3 automatically determines
the measurement mode that the operator wishes to use.
The cable and the sensor you wish to use must be connected to the RC3
before connecting it to the vehicle battery.
The technician can therefore choose between one of the following
measurement functions:
1.
Only a battery cable, no other cable or sensor connected: When the RC3
is turned on, it goes into the reading mode that allows you to acquire the
alternator signal on the battery. The green LED will BLINK TWICE indicating
that the tool has recognized the battery cable.
2.
Battery cable + PIEZO sensor cable: When the RC3 is turned on it goes
into Piezo mode (detection via a sensor which is applied to the pipes of
traditional diesel systems).
3.
Battery cable + AMP CLAMP cable: When the RC3 is turned on it goes
into AMP mode (detection via amp clamp applied to the spark plug cable).
Analogue measurements can also be carried out using the HPC cable
which we will later describe.
The HPC cable may be suggested as an alternative to the normal cable
depending on the operating environment you are working in (CAR -
TRUCK) and/or depending on the country the tool traded.
25
en