TEXA RC3 - 5 How to Use the Tool with Axone Series or Pegaso Series Viewing Units

5 HOW TO USE THE TOOL WITH AXONE SERIES OR
PEGASO SERIES VIEWING UNITS
To use the tool in combination with a viewing and processing unit of the
AXONE series or with a work station of the PEGASO series, all you need
is the IDC3 software; no other software is required.
Before starting the communication with the viewing unit you must carry
out the appropriate configuration procedure.
Follow the configuration procedure used specifically for TEXA tools. This
procedure is prompted automatically by the program at the first start-up of
the IDC3 software.
For further information see the IDC3 software operating manual.
Power, connect and turn the tool on before starting any
applications that will interface with it. This should be done in order to
avoid communication errors.
33
en