General Regulations for Operator Safety
This product has been designed and developed to be used by technical
personnel specialized in the automotive field, such as car electricians,
mechanics, technicians and engineers with an automotive specialization.
Do not allow unqualified personnel to use this appliance. This is to avoid
accidents to people or damage to the tool or to the electronic systems of
the vehicle to which it is connected.
Before operating, connecting and using the RC3, it is essential that you
read and fully understand all the safety, installation and user instructions
contained in this manual carefully.
Knowing and respecting the operating conditions and procedures
described in the manual allow operators to work safely, avoiding injury to
themselves and damage to the tool or vehicle on which he/she is working.
1.
The RC3 system must be exclusively used on 12-32 Volt direct current
vehicles with the chassis connected to the negative pole.
2.
Do not position the appliance over an airbag or in the immediate vicinity
of its expansion area. Airbags inflate with great force. If you position the
device in the airbag expansion area and the airbag inflates, the device
may be projected with great force and may cause serious injuries to the
people in the vehicle.
3.
Position the appliance in order to guarantee its correct ventilation. Do
not locate the appliance near heat sources or hot surfaces and/or parts.
8
To Next Page
Loading...