4 SAFETY RULES
The technology used for the design and manufacturing control of the TMD MK3 LTE makes
it a reliable, simple and safe device to install and use.
The personnel in charge of installing the remote diagnostic tools are required to follow the
general safety regulations, to use the TMD MK3 LTE devices for their intended use only and
to carry out maintenance correctly as described in this manual.
All the safety requirements issued by the following must be assessed and applied:
•
Labour inspectorate.
•
Trade associations.
•
Vehicle manufacturers.
•
Anti-pollution regulations.
in force in the country where the product is used.
4.1 Intended Use
Product Intended Use
TMD MK3 LTE Remote control of data on board a vehicle.
4.2 Glossary
Device:TMD MK3 LTE
Operator:qualified person in charge of installing the device.
Wiring:specific electric cables needed to connect the device to its accessories, to the power
supply, to the antenna, etc.
The definition of "operator" cannot be applied to minors or to
people with reduced physical, sensory or mental capabilities or
without any experience or knowledge required.
4.3 General Rules
The operator must carefully read and understand the information and
instructions in the technical documents provided with the device.If the
operator cannot read this manual, it is responsibility of the owner of the
equipment/employer/person in charge of the safety to illustrate the contents
of this document and adequately train the operator in relation to the operating
instructions and safety measures for a proper use of the device.
•
The operator must have basic knowledge of mechanics, automotive industry, car repairs
and of the potential dangers that can occur during installation operations.
•
The operator must carefully read and understand the information and the instructions in
the technical documents provided with the device.
en
65
To Next Page
