TEXA TMD MK3 LTE - Blink Codes; LED Flashes with the Instrument Panel on

13 BLINK CODES
The device uses the flashing of the LEDs to indicate its status.
The status LEDs are: green, red and blue and can flash with different frequencies.
13.1 LED flashes with the Instrument panel On
During normal operating conditions, when the device must connecting to the server to send
the data, the notifications are given through a continuous cycle of 3 flashes.
Each series of flashings is approximately 2 s after the previous one.
The three flashings indicate respectively the status of:
1.
The reception of the position signal from the GPS satellites.
2.
The connection to the LTE/GPRS network.
3.
The connection to TEXA Cloud.
The correct reading of the flashes of the red and green LEDs is explained below:
Flash Red LED Green LED
1° Invalid GPS position.* Valid GPS position.
2° Invalid LTE/GPRS connection.** Valid LTE/GPRS connection.
3° Invalid TEXA Cloud connection. Valid TEXA Cloud connection.
(*) INVALID GPS POSITION
This could be due to the vehicle being parked in a closed area or passing through a
dead zone where the flow of the data coming from the satellites is missing or affected
by many interferences (ex.: military areas).
(**) INVALID LTE/GPRS CONNECTION
This could be due to a problem with the telephone or Internet service providers caused
by ordinary / extraordinary maintenances on the network, by the weather conditions
or by the passage in an area not covered by the LTE/GPRS signal.
en
83