TEXA TMD MK3 LTE - Maintenance

15 MAINTENANCE
In order to guarantee a correct functioning of TMD MK3 LTE and the accessories connected
to it, you must perform regular checks on the device.
Failure to carry out the maintenance may compromise the
proper operation of the device.
We remind the operator to carry out the tests with the utmost care, making sure he/she is
working in total safety during all of the steps.
In particular:
•
Carry out a visual check of all the devices installed.
•
Make sure the device is not damaged; make sure all covers/plastic parts are properly
fastened; make sure no wiring is cut and/or damaged, no connectors are disconnected
and/or loose. Furthermore make sure the antennas are properly fixed in their installation
housings.
•
Make sure the connections are not damaged, oxidised, exposed to atmospheric agents,
water and humidity.
•
Make sure all screws and bolts used to fasten TMD MK3 LTE are not damaged and are
properly tightened.
•
If the wiring or the connections have been exposed to atmospheric agents, water and
moisture, proceed with the waterproofing.
•
In case of damaged cables, contact the Manufacturer in order to have them replaced.
If any problems or complications occur, contact the Assistance Service immediately.
en
85