11.3 Power Supply Connections
In order to power TMD MK3 LTE, the specific wiring supplied must be used.
Do not connect the connector to TMD MK3 LTE until the
entire system is completed.
Use the wiring with the loose wires.
Proceed as follows:
1.
Identify the red wire (+30 VBatt.), the yellow wire (+15 V key-on) and the black wire
(ground).
2.
Draw power for the +30 VBatt line directly from the vehicle's battery.
Connecting the yellow wire (+15 V key-on) is MANDATORY.
Make sure the +30 V and ground power supplies are correct
in order to avoid the arising of false alarms from the TMD
MK3 LTE control unit (discharged battery alarm, power
disconnection alarm).
80
To Next Page
