1 About this Manual
This user's guide describes the TPS65994 EVM. The guide consists of an introduction, setup instructions, the
EVM schematic, board layouts, component views, internal power (PWR) and ground (GND) plane layouts, and a
bill of materials (BOM). Refer to TPS65994QFNEVM schematic, board layouts, component views when
evaluating TPS65994 QFN package.
2 Items Required for Operation
The following items are required to use the TPS65994 EVM:
• TPS65994 data sheet
• TPS65994 EVM
• TPS65994 Application Customization Tool
• 20-V barrel jack adapter or DC power supply
• Passive USB Type-C™ cables
• USB Type-A to USB Micro-B cable
• USB Type-A to USB Type-B cable
• Mini-DisplayPort to DisplayPort cables
• DP-Expansion Board
• Notebook with USB 2.0, USB 3.0, and DP capabilities
3 Introduction
The TPS65994 is a stand-alone USB Type-C and Power Delivery (PD) controller providing cable plug and
orientation detection at the USB Type-C connector. Upon cable plug and orientation detection, the TPS65994
communicates on the CC line using the USB PD protocol. When cable detection and USB PD negotiation are
complete, the TPS65994 enables the appropriate power path and configures external multiplexers and alternate
mode settings. This user guide describes how the TPS65994 EVM can be used to test DisplayPort alternate
mode as well as USB Data. This guide also contains testing procedures of DP alternate mode as well as various
PD power configurations. The EVM is customizable through the TPS65994 Configuration Tool. Additionally, the
EVM is equipped with Tiva MCU and Aardvark connector to SPI or I2C interfaces for debugging and
development.
www.ti.com
About this Manual
SLVUBM1C – JANUARY 2019 – REVISED JANUARY 2021
Submit Document Feedback
TPS65994 EVM User Guide 3
Copyright © 2021 Texas Instruments Incorporated
To Next Page
Loading...
