18
Adjusting the belt tensioner
Illustration 11
The belt tensioner should be checked and adjusted
after every 5 hours use, or if self-drive problems.
1. Remove the rear pulley/belt cover
2. Loosen the knob (B)
3. Pres/push the belt tensioner (C), which is placed
behind the first pulley, towards left against the belt
with right hand, while tightening the knob again
with left hand, while holding it against the belt.
4. Fasten the pulley/belt cover again.
Storage and maintenance
Maintain your lawnmower: Check all bolts, screws,
nuts and deck. Dismount the blade and the belt plastic
cover for regular cleaning. Always make sure that the
blade is sharp. It’s a good idea to take your lawn mower
to an annual service check with your authorized service
dealer. See your nearest service center at
www.texas.dk.
Storage: After use the lawnmower kept in a dry and
clean room. Clean the machine after every use. Grass
and dirt must be removed from the underside of the
deck. By tipping the mower (for cleaning) is
recommended to tilt the front up (max. 45 degrees). If
you tilt it sideways, the carburetor and air filter always
face upwards, since oil may run out and destroy the
engine. Be aware that removing the spark plug before
the mower maintenance.
Winter storage: Empty the fuel tank and let the engine
run until the gasoline in the carburetor is used up. Spark
plug removed. Remove the spark plug and add a
teaspoon of oil (engine oil) in the hole. Pull the starter to
distribute oil. Mount the spark plug, but not the spark
plug cap. Change oil as described in the section above.
Spray silicone lubrication into the cables and move
them.
and luricate metal parts to prevent rust.
Technical data
Warranty terms and
conditions
The warranty period is 2 years for private end users in
EU countries.
Products sold for commercial use, only have a warranty
period of 1 year.
The warranty covers material and/or fabrication faults.
Restrictions and requirements
Normal wear and replacement of wearing parts are
NOT covered by the warranty.
Wearing parts, which are NOT c
overed for more than
12 months:
• Blades
• Cables
• Belts
• Fuses
• Switches
• Membranes/gaskets
• Spark plugs
• Engine liquids (oil, gasoline)
• Starter cords
• Filters
If you start the engine without adding oil, it will be
damaged and cannot be repaired and therefore not
covered by the warranty.
The warranty does NOT cover damages/faults
caused by:
• Lack of service and maintenance
• Structural changes
• Exposure to unusual external conditions
• Damages to the bodywork, deck, handles, panels
etc.
• If the machine has been improperly used or
overloaded
• Wrong use of oil, gasoline or other liquid types,
which are not recommended in this user manual
• Bad or dirty gasoline, which results in
contamination of the fuel system
• Use of unoriginal spare parts.
• Other conditions where Texas cannot be held
responsible.
Whether a case is a warranty claim or not is
determined in each case by an authorized service
center. Your receipt is your warranty note, why it
should always be kept safe.
REMEMBER: The purchase of spare parts as well as
any request for warranty repair, art. Number, year and
serial number should always be informed. It can be
found on the CE-label.
Net weight 60 kg
Net weight 59 kg
To Next Page
Loading...
