Overview Premier Series Master User Guide
10 INS177
Zone Faults During Arming
Before attempting to arm the system, ensure that the premises are secure (all doors and
windows closed etc.) and the Ready light is on.
If an attempt is made to arm the system with any zones active (e.g. door ajar, open
window, etc.) the internal sounders will bleep repeatedly (fault tone) and the display will
show the zones that are active.
O(1,$>>A$%/3.-,
*&(13$H((&
The fault tone will stop and the exit tone will resume when all zones are secure. If it is
necessary to leave a zone open then it must be omitted (see page 21 for details).
!"
If an active zone cannot be secured then it may be ‘in fault’ in this case contact the
alarm company immediately.
Arm Fail - Failing to Arm
If the exit procedure is started and zones are still ‘Active’ at the end of the exit procedure,
an Internal alarm will occur (internal sounders only) and the strobe light on the external
sounder will flash.
!"
If this occurs the arm fail must be cleared and the zone in fault identified before the
system can be armed (see page 18 for details on clearing an Arm Fail).
The Ready LED
To help prevent faults during arming, a Ready light has been provided. The Ready light
works as follows:
• If the Ready light is ON then all zones are secure and the system is ready to be armed
• If the Ready light is OFF then one or more zones are active, either secure or omit
these zones before proceeding
• If the Ready light is FLASHING then the system has zones (with the ‘Force Omit’
attribute) that are active, check these zones before proceeding.
To Next Page
Loading...
