Texecom PREMIER 88 - Setting up the Part Arms

Premier Series Master User Guide Programming the Alarm System
INS177 53
Setting up the Part Arms
When a Part Arm 1, 2 or 3 is selected, pre-programmed zones are omitted to allow
access to certain parts of the building. This option allows these zones to be programmed
or altered by any User that has access to the ‘Omit’ menu.
To set up the Part Arms, proceed as follows:
Enter a valid User code
1111
, the display should look like this:
K($6(=$9"13$3(
%&'$+653,'E
2
Press
+
K($6(=$9"13
P5,&$7,1=E
Press
#
K($6(=$9"13$3(
Q.,9$0-,13$C(2E
Press
'
K($6(=$9"13$3(
%#3,&$8"&3$%&'5E
Press
#
*(&$8"&3$%&'$A
O(1,$>>A$.5$L$:Z
Press
%
to select Part Arm 1
Press
&
to select Part Arm 2
Press
'
to select Part Arm 3
*(&$8"&3$%&'$@
O(1,$>>A$.5$L$:Z
Enter a zone number
111
or use the
*
key to search
*(&$8"&3$%&'$@
O(1,$>A>$.5$L$:Z
Press
$
to turn zone ON or OFF for the selected Part Arm
*(&$8"&3$%&'$@
O(1,$>A>$.5$L:**
Repeat for other zones
Press
+
when finished
Press
)
to exit the menu
The display will return to normal.