Operating the Alarm System Premier Series User Guide
32 INS177
Remote PC Reset A reset has been performed by the remote download PC
FUSE #,# FAIL The Auxiliary 12V Fuse in device #,# has failed
AC POWER The control panel has registered a AC Mains failure
LOW BAT The control panel has registered a low battery condition
POWERED UP System Power Up (without doing a factory restart)
BELL FUSE The control panel Bell Fuse has failed
LINE FLT There is a problem with the telephone line
Panel Line Fault The control panel line fault input has been activated
Redcare Line Fault The Redcare has detected a line fault
Com??? Line Fault The Com300, 2400 or ISDN has detected a line fault
Exp #,# Line Fault The Input on expander #,# has been activated
COMS FAILED The Communicator has failed to report to the Alarm Receiving Centre
DOWNLOAD START An Upload/Download has been initiated
DOWNLOAD END The Upload/Download has finished
LOG ALERT 80% of the Event Log has filled (since the last Upload/Download)
DATE CHANGED The control panel Time has been changed
TIME CHANGED The control panel Date has been changed
Event Log Hotkeys
When viewing the system log there are 8 hotkeys available. These hotkeys allow certain
events to be found easier without the need for searching.
The following hotkeys are available:
!
= Priority Alarms (PA, Fire etc.)
0
= Normal Alarms (Guard, 24hr, Entry/Exit etc.)
,
= Opens and Closings (Arm, Disarm etc.)
-
= Omits and Reinstates (Zone Omits etc.)
4
= Maintenance (System Tests, Engineer Program etc.)
.
= Tampers (Zone, Bell, Aux etc.)
/
= Test Calls (Communicator Active, successful etc.)
5
= Entry/Exit (Entry and Exit Procedures)
3
= User Codes (User codes being used)
To Next Page
Loading...
