Premier Series User Guide Operating the Alarm System
INS177 21
To OMIT Zones
It is possible to exclude (omit) individual zones when arming i.e. if a zone is ‘in fault’. Users
with access to this function can only omit zones that have been programmed as ‘Omittable’.
!"
If the zone can be omitted, there will be a star to the right of the zone number.
Only zones that have the ‘Omit’ attribute assigned to them can be omitted.
A star will appear to the left of the zone number to indicate that the zone has been
selected for omitting.
All omitted zones will be automatically reinstated the next time the system is
disarmed, unless programmed otherwise.
To re-instate zones manually, simply follow the instructions again. However, when
the
%
key is pressed this time, the zones will be re-instated.
To omit zones when arming, proceed as follows:
Enter a valid User code
1111
and press
%
O(1,$>>AI+,/=&,
*&(13$K((&$$$$$L
Enter a zone number
111
or use the
*
key to search
O(1,$>A>I%/3.-,
C(=12,$K,3,/3(&$L
Press
%
to omit the selected zone
O(1,I>A>I%/3.-,
.5$:'.33,H
O(1,I>A>I+,/=&,
C(=12,$K,3/3(&$L
Repeat for other zones if required
Press
+
when finished
K($6(=$9"13$3(
%&'$+653,'E
Continue to arm the system as normal
The selected zones are now omitted (the omit light will be on).
To Next Page
Loading...
