Texecom Veritas R8 - Miscellaneous Selections Two; Miscellaneous Selections Three

Programming
22 INS 034-9
Disclaimer:
It is the responsibility of the Installer to guard against losing locked Engineer
codes. Texecom accept no liability whatsoever for any loss resulting from
locked Engineer codes.
3.2.3 Miscellaneous Selections Two
!#
From the Programming Menu,
enter
!#
.
The zone lights of the options currently
selected will illuminate.
Press the appropriate numbered button(s) to select or
de-select the corresponding option(s) as shown on the display. Press
,
.
The system will chime to confirm the new options have been accepted. The
system will then automatically revert to the Programming Menu and all the zone
lights will illuminate.
Option Miscellaneous Selections Two Factory Setting
1 Engineer Reset on Any Alarm (see section 3.2.5, page 23) Off
2 Engineer Reset on Tamper Alarm (see section 3.2.5, page 23) Off
3 Disable User Ability to Omit Tamper Off
4 Code PIN Tamper (tamper alarm after 16 invalid key presses when unset) Off
5 Random Number Remote Reset (RNRR, see section 3.2.5, page 23) Off
6 Push To Set (see section 3.2.6, page 24) Off
7 Strobe Flash on Full Set On
8 Invert Switched Positive Output (off = negative removed, on = negative applied) Off
3.2.4 Miscellaneous Selections Three
!$
From the Programming Menu,
enter
!$
.
The zone lights of the options currently
selected will illuminate.
Press the appropriate numbered button(s) to select or
de-select the corresponding option(s) as shown on the display. Press
,
.
The system will chime to confirm that the new options have been accepted. The
system will then automatically revert to the Programming Menu and all the zone
lights will illuminate.
Option Miscellaneous Selections Three Factory Setting
1 Mains Frequency (off = 50Hz, on = 60Hz) Off
2 Reserved for Future Use Off
3 Reserved for Future Use Off
4 Reserved for Future Use Off
5 Reserved for Future Use Off
6 Reserved for Future Use Off
7 Reserved for Future Use Off
8 Reserved for Future Use Off
If the wrong Mains Frequency is selected the panel will indicate a power fault.