Texi Joylock 2/466
EN
2. STARTING TO SEW
THREADING YOUR MACHINE
Wrong threading may cause shipped stitches, breaking threads, or other problems.
Try to master the correct threading before moving on to test sewing.
Threading must be carried out in the sequence of Lower Looper – Upper Looper –
Needle.
Open the front cover and the working table.
Raise needle to its highest point by turning hand wheel towards you, and raise the
presser foot.
Before re-threading lower looper, remove thread from needle eye rst, then re-
thread the lower looper. This will prevent tangling.
NOTE: Thread tension is released when the presser foot is lifted up.
To Next Page
Loading...
