Texi Joylock 2/4 79
EN
3. CARING FOR YOUR MACHINE
REPLACING MOVING CUTTER
DISENGAGING MOVING CUTTER
REMOVING FACE COVER
Replace a moving cutter if it becomes blunt
as follows. A spare cutter will be found in your
accessories.
NOTE: You should not need to replace xed
cutter, which is made of special hard alloy
material.
FIRST REMOVE THE POWER PLUG FROM THE
SUPPLY SOCKET-OUTLET.
1. Loosen screw and take out moving cutter.
2. Close the working table. Lower cutter
driving arm to its lowest position by turning
the hand wheel towards you by hand. In
this position, set replacement cutter in
position and secure it with screw, ENSURING THAT THE EDGE OF THE MOVING
CUTTER IS APPROXIMATELY 0.5 MM BELOW THE SURFACE OF THE FIXED CUTTER.
If you want to sew without cutting, open the
working table and disengage the moving cutter
by pushing the cutter release knob to the left and
turning it towards you as illustrated.
Ensure that fabric edge is not wider than
overedge width selected or upper looper and
needle can be damaged.
Disconnect from power supply before
removing face cover.
Remove the screw and take o the face
cover.
To Next Page
Loading...
Need help?
General
