Texi Joylock 2/4 71
EN
TEST SEWING
After threading is completed, use a
scrap of fabric that you plan to sew
and test to sew in the following order.
1. Gently pulling all the threads to the
left, lower the presser foot. Rotate
the hand wheel towards you a few
times to see if the lock stitches are
properly formed.
2. Start the machine at low speed and
feed in test fabric under the presser
foot by slightly pushing it forward.
(This can be done with the presser
foot down on most fabrics except
bulky materials.) Guide the fabric
gently as machine automatically
feeds the material.
3. Check thread tensions by test
sewing on spare fabric.
4. At fabric end, carry on running
machine at low speed, gently
pulling the fabric towards the
back,until about 5 to 6 cm of extra
lock stitches are produced without
fabric.
5. Cut thread by pushing thread cutter
lever down, or with scissors.
To Next Page
Loading...
Need help?
General
