Texi joylock 2/4 - Machine Conversion Procedures; Converting to Two-Thread Use

Texi Joylock 2/4 73
EN
CONVERTING TO TWO-THREAD
To convert to two thread use, rst open the front cover and working table and raise
needle to its highest point by turning hand wheel towards you. Remove the right
needle and use the left needle.
Please keep the unused needle on the needle pad.
Pull out the convertor as shown in Fig.1.
Attach the two-thread convertor onto the upper looper as shown in Fig. 2, Fig.3.
When not using convertor, insert it deep and keep as illustrated in Fig.4.