ADJUSTMENTS 10
66
10.10STEERING ADJUSTMENT___________________________________________________
Steering Toe-In Adjustment
a Turn the rear wheels to the straight position.
b Loosen the jam nuts on both ends of the tie rod.
c Rotate the tie rod to get the correct toe-in. the Toe-
in must not be more than +1/16 inch (+ 0.15 cm).
d Tighten the jam nuts.
Steering Stop Adjustment
When the toe-in is adjusted, turn the steering wheel to
the left to extend the steering cylinder rod. When the
steering cylinder rod is completely extended, the steering
spindle arm must be 3/4 ± 1/16 inch (1.9 ± 0.15 cm) from
the axle stop. Turn the steering cylinder rod into or out of
the ball joint to adjust the steering stop position.
X
X+ 0 to 1/16 In.
(X + 0 to 0.15 cm)
3/4 ± 1/16 in.
(1.9 ± 0.15 cm)
Jam
Nut
Jam
Nut
Tie Rod
Ball
Joint
Axle Stop
Spindle
Arm
To Next Page
Loading...