Textron MPE 850 MARINE - Page 62

62 SHB MPE850 Rev F | 408014 | 408090 | 408101 | 408246 |
5
3
7
1
8
16
2
6
4
18
22
20
21
17
19
23
24
25
► Put the valve cover
16
on.
► Apply Anti-Seize assembly paste to all bolts
17
.
► Screw in the bolts in the sequence as
illustrated
18
.
Tightening torque:
8 Nm +2 Nm [5.9 lbf ft +1.5 lbf ft]
► Insert the ignition coils
19
.
► Replace the serrated lock washers
20
.
Assemble the bolts
21
, washers
22
and
serrated lock washers as illustrated.
Tightening torque:
8 Nm +2 Nm [5.9 lbf ft +1.5 lbf ft]
► Connect the wire harness connectors to the
ignition coils
23
and sensor camshaft
24
.
► Touch up paintwork defects.
► Clear the service counter to reset service
light. (See the Textron Motors Diagnostic
Tool manual.)
► Update the engine control unit calibration.
(See the Textron Motors Diagnostic Tool
manual.)
8 Service tasks in the workshop
8.5 Checking and adjusting valve lash
► Attach and press down on the engine cover
25
until it snaps into place.
► Test-drive the vehicle.