MANUAL P/N 900000165 REV H
So to modify the ETH2 port configuration the following sequence should be followed:
Press left
Main > Ethernet
<- [OK-enter]
Press OK [OK-enter]
Main > Ethernet > ETH1
[OK-enter] ->
Press left [OK-enter]
Main > Ethernet > ETH2
<- [OK-enter] ->
Press OK, this shows the current configuration for port ETH2. This shows, on line 2, port name,
and the IP address. The netmask is shown as a bit count rather than in the dotted notation. In
this example 24 means 255.255.255.0, i.e. 24 set bits in the mask. Finally on the line is the
gateway address.
[OK-enter]
ETH2 Current config. [OK-edit] [^ exit]
ETH2 192.168.102.99/24 192.168.102.34
Press OK to modify this configuration. The following display is shown. The Left/Right keys cycle
through fields, the field selected is indicated by an underline on its first character. The up/down
keys change values. OK will exit except without saving changes except when save is selected
first, then changes will be applied.
ETH2 Edit [OK-exit/save </>-sel ^+/V-]
192.168.102.098/24 192.168.102.034 SAVE
ETH2 Edit [OK-exit/save </>-sel ^+/V-]
192.168.102.098/24 192.168.102.034 SAVE
Selecting SAVE then pressing OK applies the changes:
ETH2 Edit [OK-exit/save </>-sel ^+/V-]
Updating port ETH2
To Next Page
Loading...