MANUAL P/N 900000165 REV H
Menu will return to Current config, showing the now updated address information.
[OK-enter]
ETH2 Current config. [OK-edit] [^ exit]
ETH2 192.168.102.98/24 192.168.102.34
Press the up key to exit this menu. If after a short period a key has not been pressed the display
reverts to the main status display. Ensure that the unit is not left unattended in the port edit
page.
The GPS status information that can be shown on the front panel is shown below. This is an
example power up sequence following on front the NTP80plus identification message at the
start.
Example GPS start-up sequence…
Run-time: 0d 00:01:00
12 GPS 0 ST: No GPS time yet
Run-time: 0d 00:01:53
12 GPS 1 ST: No usable sats
Run-time: 0d 00:02:10
12 GPS 1 ST: Only 1 usable sat
Run-time: 0d 00:02:23
12 GPS 2 ST: Only 2 usable sats
Run-time: 0d 00:02:31
12 GPS 3 ST: Only 3 usable sats
There may be other messages during this sequence.
Run-time: 0d 00:05:00
12 GPS 4 ST: Normal
To Next Page
Loading...