TFT HURRICANE Series - Inlet Mounting and Range Adjustments; Inlet Fitting & Extend-A-Gun Attachment

©Copyright Task Force Tips LLC 2004-2020 15 LIX-300 October 23, 2020 Rev22
4.3 INLET MOUNTING AND TRAVEL RANGES
4.3.1 INLET FITTING OR EXTEND-A-GUN INSTALLATION
The Hurricane RC Monitor is available with various inlet fittings. The Hurricane RC Monitor also connects directly to TFT’s Extend-A-Gun
RC3 or RC4. The fittings and Extend-A-Gun RC are attached to the monitor by means of a threaded joint with an o-ring seal. Install the
monitor using the following procedure:
VSA-125
VSA-125
Y4437
VW360x200-04
Y4435
VT10-32SH1.2
Apply VSA-125 blue Loctite to threads on both
Cylinder Nuts.
MONITOR BASE CLAMP
WASHER
SOCKET HEAD SCREW
10-32 X 1-1/4 LONG
CYLINDER NUT
BLUE LOCTITE
BLUE LOCTITE
STEP 1

&</,1'(5187
+($'*5229(
7236,'(2)&/$03
$OLJQJURRYHVLQKHDGVRI&\OLQGHU1XWVZLWKWRS
VLGHVRI&ODPSV
6OLGH6FUHZVWKURXJK:DVKHUVDQG&ODPSV
/RRVHO\WKUHDG6FUHZVLQWR&\OLQGHU1XWV
67(3

(;7(1'$*81
0$/(287/(7
7+5($'6
7236,'(
2)&/$036
/226(&/$03
$66(0%/<
&</,1'(5
187+($'
3ODFH&ODPSDVVHPEO\RYHUPDOHWKUHDGVRI
RXWOHW
&\OLQGHU1XWKHDGV0867EHRQWRSVLGHRI
&ODPSV
67(3