©Copyright Task Force Tips LLC 2004-2020 3 LIX-300 October 23, 2020 Rev22
TABLE OF CONTENTS
1.0 MEANING OF SAFETY SIGNAL WORDS
2.0 SAFETY
3.0 GENERAL INFORMATION
3.1 MECHANICAL SPECIFICATIONS
3.2 ELECTRICAL SPECIFICATIONS
3.3 OPERATING ENVELOPE
3.4 USE WITH SALT WATER
3.5 VARIOUS MODELS AND TERMS
3.6 INLETS AND OUTLETS
3.6.1 INLET OPTIONS
3.7 OVERALL DIMENSIONS
3.7.1 OVERALL HEIGHT INCREASE FOR INLET FITTINGS
4.0 INSTALLATION
4.1 ELECTRICAL INSTALLATION
4.2 STRUCTURAL REQUIREMENTS
4.2.1 MOUNTING THE MONITOR
4.3 INLET MOUNTING AND TRAVEL RANGES
4.3.1 INLET FITTING OR EXTEND-A-GUN INSTALLATION
4.4 CABLE ROUTING FOR EXTEND-A-GUN
4.5 HORIZONTAL ROTATION TRAVEL STOPS
4.6 ELEVATION TRAVEL STOPS
4.7 NOZZLE INSTALLATION
4.7.1 ER NOZZLE INSTALLATION ORIENTATION
4.8 PRESSURE GAUGE PORT
4.9 AUTOMATIC DRAIN
4.10 TILLER/HANDLE INSTALLATION
5.0 OPERATING INSTRUCTIONS
5.1 HORIZONTAL ROTATIONAL CONTROL
5.2 HANDWHEEL ELEVATION CONTROL
5.3 RECOMMENDED PARK POSITION
5.4 OVERRIDE KNOBS
6.0 FLOW CHARACTERISTICS
6.1 MST-4NJ STACKED TIPS FLOW AND REACH
6.1.1 EFFECTS OF ELEVATION AND WIND ON STREAM REACH (2.00” TIP)
6.2 AUTOMATIC MASTERSTREAM NOZZLES
6.3 FRICTION LOSS
6.4 STREAM STRAIGHTENERS
6.4.1 STREAM STRAIGHTENERS WITH STACKED TIPS
6.4.2 STREAM STRAIGHTENERS WITH FOG NOZZLES
7.0 WARRANTY
8.0 MAINTENANCE
8.1 SERVICE TESTING
8.2 LUBRICATION
8.2.1 ELEVATION CONTROL WORM GEAR
8.2.2 HORIZONTAL ROTATION WORM GEAR
8.3 TROUBLESHOOTING
8.4 REPAIR
9.0 EXPLODED VIEWS AND PARTS LISTS
10.0 OPERATION AND INSPECTION CHECKLIST
To Next Page
Loading...
Need help?
General
