EasyManuals Logo

Thales Cinterion LGA DevKit Series User Manual

Thales Cinterion LGA DevKit Series
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
Cinterion
®
LGA DevKit User Guide
4 LGA DevKit Interfaces
35
t lga_devkit_ug_v03 2020-05-29
Public / Released
Page 12 of 36
4 LGA DevKit Interfaces
4.1 USB
The LGA DevKit comes with two USB interfaces supporting power supply and serial commu-
nication. You may choose to setup communication via a module's USB port and/or a module's
UART (ASC0) port via FTDI232R VCP.
Both USB ports can be used in parallel while power is sourced from both ports.
The native USB power is isolated from the VCP USB power by a diode, meaning that the
VCP USB power does not feedback to the native USB power, but vice versa. This should
be taken into account when supplying the LGA DevKit from different USB power sources,
depending on the voltage levels there could be a power feedback from native USB to VCP
USB.
In case of marginal USB power supply both USB ports should be used to improve power
capabilities.
Note: The modem's USB driver can be downloaded from the LGA DevKit's web page that can
be reached by scanning the QR code.
4.2 SIM
On the LGA DevKit's underside you find a SIM card holder that is con-
nected to the module's regular SIM interface lines, except for the
CCIN line where the (default) jumper needs to be set for CCIN at the
CONTROL pin headers (see Section 4.3). However, some modules
come with an additional SIM interface. This can be accessed in con-
junction with a DSB75/DSB-Mini (as port extender) to support dual
SIMs - with the DSB75/DSB-Mini serving as the second SIM interface.
Some Cinterion
®
modules require additional components at the SIM
interface, for instance pull-up resistors managed by the DevKit's con-
trol logic. These can be overridden by setting a switch on the DevKit's
underside - see Figure 6. For modules requiring a CCIO pull up resis-
tor this switch should be set to "CCIO PULLUP" (see Section 7.3).
Figure 6: SIM settings

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Thales Cinterion LGA DevKit Series and is the answer not in the manual?

Thales Cinterion LGA DevKit Series Specifications

General IconGeneral
BrandThales
ModelCinterion LGA DevKit Series
CategoryMicrocontrollers
LanguageEnglish