-Fill out all the necessary details and choose your parameters
1. Name your task - This is how it will appear in the task list.
2. Choose your backup mode –
-Synchronization mode - Makes your source match your target
completely; deleting and adding files on your target as
they are deleted and added on your source.
-Incremental Mode - Makes your source match your target and keep
all old files; adding files on your target as they are
added on your source, but NOT deleting files on your
target as they are deleted on your source.
3. Choose your source folder(s) - These are the folders on your source NAS
that you wish to backup.
4. Input your target’s IP address and port number - This is the NAS which
you are going to use as a backup, port number is
optional.
5. Input your destination folder and create a backup folder – Your
destination path is the name of an existing folder on
your NAS where you wish to backup your .
6. Input your username and password - This is the username and password
you set in “Rsync Target” on your target NAS.
To Next Page
Loading...
Need help?
General
