Thecus 1U4600 User Manual

74
DHCP Server Configuration
A DHCP server can be configured to assign IP addresses to devices connected to the
LAN2 port. To configure these ports, choose LAN2 from the System Network
menu.
DHCP Configuration
Item Description
DHCP Server Enable or disable the DHCP server to automatically assign IP
address to PCs connected to the LAN2 interface.
Start IP Specifies the starting IP address of the DHCP range.
End IP Specifies the ending IP address of the DHCP range.
DNS Server Displayed the DNS server IP address.
LAN3(For the N8900)
LAN3 Configuration
The N8900 supports three Gigabit Ethernet ports for higher service availability. To
configure these ports, choose Additional LAN 3 from the System Network menu,
and the Additional LAN3 Configuration screen appears. Press Apply to save
your changes.
Additional LAN3 Configuration
Item Description
MAC Address Displays the MAC address of the LAN3 interface.
Jumbo Frame Support
Enable or disable Jumbo Frame Support on the LAN3 interface.
IP Specifies the IP address of the LAN3 interface.
Netmask Specifies the Network Mask of the LAN3 interface.
Gateway When Thecus NAS as a DHCP server from LAN3, it can have
another route to balance traffic bandwidth for its DHCP
clients
Link Detected Specifies the LAN3 port link status
Lick Speed Specifies the LAN3 port link speed
NOTE
The IP Segment of WAN/LAN1 and LAN2 should not overlap.
WARNING
The IP address of the LAN2 interface should not be in the range of the
Start IP address and End IP address.

Thecus 1U4600 Specifications

General

Brand	Thecus
Model	1U4600
Category	Network Storage Server
Language	English